All I have is a wire welder , think that would work ?If you're really carefull, you can drill some 1/4" holes in the panel where the spot welds are
and mig them in without too much heat damage to the surrounding paint. Prime and paint
the support before you weld it in. You'll have a minimum of touch-up later. Good luck!
Can’t see picsYes! as Dadsbee illustrated with the Excellent pictures, you can mig that baby right in!
Is there a specific spot the brace is supposed to be on the frame rails to clear the floor? The bump stop holes and middle braces are in different places on each frame rail while they’re test fitted so I’m not sure I can use them to get the brace in line