Search results for query: *

I'd use the 5.9 mag engine and heads, with that engines correct cam set. Put the eddy spread bore intake on and the thermoquad plus the headers.

RIP

Welcome from Iowa.

RIP, Funny guy, good actor.

Yes, all these new carbs are put together by people who will never use one. Edelbrock builds a great carb but it's a crap shoot if they are adjusted to spec when boxed. Float levels way off are a real issue with them. On your distributor, if you have a new repop orange box we have seen many...

If I remember ,those headliner strips are held in place by clips that rotate 90 degrees. Once each clip is turned it will release that strip.

Yes, the trim has nuts on the inside. If I recall they are the speed nuts on cast/ pot metal studs on the trim .

I like the 3.23s with a 26" rear tire.

You say you have fuel. I'm going to figure your looking at a good pump shot out of the nozzles of that afb. So your down to spark. Is your dwell set between 28 to 32 degrees? New condenser is hooked up. Take one of the plugs out , put the plug wire back on and ground the plug to the exhaust...

I like the guys and their shows. They are a breath of fresh air compared to the main stream car shows.

Thanks, Yes I'm sure there is some moisture in the bad areas of the masonite. Makes sense to remove it all. I'm just getting lazy lol.

My 24x24 detached at our home has the original 12" masonite siding with the 4x8 sheets of black board under. Areas around the brick mold are getting soft and flaking, Bottom pieces have some rot in places. Our house has vinyl siding and I want to use the same on the garage. I figure I can not...

Good start on the body.

Welcome from Iowa.

Heck yeh, keep everything. Bag and tag. It's not out of hand unless the kids call a TV show to come over.

I can not add much except , Sorry man.

How are your torsion bars set ?

I will get you a couple pics later today.