Search results for query: *

Here’s an update on what we found. I have a stock 361 with correct AFB carb and Carter fuel pump. I was totally convinced the problem was fuel or fuel system.. Car was really difficult to keep running after starting yesterday. Once warmed up a bit it would idle - but even the slightest amount...

Well, we never did get to work on it today. Man it better not be water in the gas. That will really tic me off.

This afternoon my buddy is going to help me figure out what is going on with my 62’ Fury - 361/4. I’ve had recent carpal tunnel surgery on both hands so can’t do much myself. Saturday I had it out for my first cruise this year. It started and ran very well 11-12 miles into town for the cruise...

Duplicate

Thanks guys!

You mean right by the bell housing, top rear?

On a 62’ 361 engine, where is the oil pressure sensor located for the idiot light? Not for an actual measurement gauge.

Put KYBs all around on my 62 Fury last year. Huge improvement over what was on it and not at all harsh. Only a couple bucks a piece more than Monroe’s..

Someone repops them. I’ve seen them someplace but can’t recall where.

Protect your steering column with some tape, pull the steering wheel and push up on the padded dash cover as you are pulling the cluster out…

High Zinc might not be necessary for a full roller engine but it’s still the best thing to use in my opinion. As long as there is no catalytic converter on the engine I would use high zinc in everything.

Stumper added a new event: Farmington Mopar Show Read more about this event...

Coming up on May 11th at the Farmington Dragway in Farmington, NC. Best Mopar Show in the Carolinas. Professionally classed and judged car show, large swap meet and 1/8 mile race fun. 2992 NC Hwy 801 N Mocksville, Nc 27028

Has anyone used one of the heavy gear hand crank winch on a trailer? They have them up to 3500lb. My trailer sits in the weather all the time.

I think so but the fronts are 6” with whatever is standard BS on Torque thrusts.

They certainly handle a lot better. This car is all about originality so the steel/bias plies are really appropriate for it. They are just not very road friendly in these parts…

I know I have my Fury here someplace but don’t think it’s in this thread. 62’ Fury (not Sport). 361 4bbl, 727, 3:23 gears, all stock and close to 100% original. I’ve been showing it with the correct steel wheels and bias ply tires but don’t think I’ll bother this year. An old man’s cruiser!

Nobody needs this? Open to offers.

Don’t see how it could damage it any..

Thanks Kid, just what I needed.