Search results for query: *

Can’t remember the number. It’s in the owners manual (online)

That is your fuel bowl vent, similar to the center carburetor on a six pack setup. If fuel comes out there, you either have a “sunk float” with a hole in it OR a needle & seat that is stuck open. The float and needle&seat work exactly like a toilet. Water (or gas) fills up, float goes up & shuts...

You need a price. They’ll go to a good home here

Others here know more….but if you have a driveshaft that’s the correct length and attaches that “trunion” (?) tail shaft, I think you’re in good shape….maybe the shifter needs changing? Maybe not? You need pedals, a tang (?) to weld on the frame to connect to the z-bar (linkage), make sure your...

Maybe check the hole diameter compared to a side marker bulb socket?

Dr diff is the favorite here, but moser or strange axles are good too. I’m not sure about Yukon

Why are you pulling the motor? Not needed to replace the oil pan (fyi)

I just did this with “decent” results. I used a 1-component moisture cure polyurethane and some hardware store wood clamps. I think you could soften the vinyl VERY CAREFULLY with a heat gun (???)

I believe that means one or more bearing was .001” oversized from the factory. If it has an “x” thenone or more bearings is .010” oversized from the factory. Looks like 5,2,3 are .010” oversized (not sure if that’s rods or mains….I think it’s right at the front of the engine section in the...

Put too many in the box by mistake

What engine?

You will fail California emissions (if required) without a PCV valve

Shroud for sure. It concentrates the “pull” of the fan through the radiator

I don’t know what carburetor you have. Check online for the idle mixture screw. The CRC stuff is supposed to clean catalytic converters and I’m not sure if it works.

I suggest you fiberglass back the missing piece

I just read an emissions tip that said high CO means it’s running rich. Is your California test at idle? On a treadmill? The article mentions a dirty air filter & another poster’s idea about leaning out the idle mixture screws (more air, less fuel) would help

I’d say that’s a very good deal. The A/C situation confuses me….i see a/c dash but no a/c under the hood.

$8 https://www.megapartsusa.com/proddetail.php?prod=159-OVP625

Rookie question - would a different steering box clear?

Look for a "dolphin" fuel gauge adjuster. I just installed one, but haven't calibrated it yet, so I can't swear it works. It's small and has buttons inside & a screw adjuster.