Search results for query: *

Forgeline

.

The Bat flu?

R.I.P. OZZY

Could be catching on a ridge or bearing normally they slide easily even with the steel rings

Bit of extra work flushing & bleeding but 2 years now without any issue

Put up a pic of the pump support & input shaft metal seal area

Does the circlip go on the rear planetary spline OK. Check the tail extension housing if the bolts are too long they will push the sprag drum forward Have you tried putting together without the thrust washers is it still binding Also is the pump support & the front drum a matched set

Drinking

Happy Birthday

Someone needs to pull that tie his wearing up a few notches

His old man is just as guilty

We have a heap of them here all with huge fart cannons sticking out the rear

I asked AMD if they will be making the 72 Roadrunner rear bumper they replied they had no plans to that was 8 months ago

Do not hold the steering wheel if attempting the centring procedure the hydraulics are strong enough to break your wrist if adjusted to far

I put it up on page 1 what does the base look like i have a Challenger base no rails could be the same left or right

They look the same as the door scuff plate screw large head chrome

Got 1 hook only 3/16" UNC thread cheapest air bag $17 AUD hook is free

I will have a look have couple of old seats here in Perth

Anyone know about the operation of the 46RH i rebuilt the unit when i run the transmission unloaded on a test engine i can select reverse,1st ,second & third & the output shaft changes speed. When i put power on the 2 overdrive wires nothing happened does the transmission need to be loaded...