Search results for query: *

Glad to help.

Might want to check out Harmon Classic Brakes for parts. Home - Harmon Classic Brakes

Pull the radiator and have a radiator shop clean it out. Fan shroud is also a big help. Put a spring in that lower hose to prevent collapse. and get a FlowKooler water pump with hi flow 180 thermostat. .

Keep in mind that engine timing can have a significant effect on engine operating temperature..

You need to get a wiring schematic for your car and start tracing out the wires involved one by one. Something is mis wired, especially if everything worked prior to the re-wire.

About 8 years ago I replaced my defective standard oil pump with a hi volume oil pump pump on my 66 383. I had not changed out an oil pump before so I did some reading up on the process before doing it. I found a thread, that I recall was on this forum, that suggested packing the new pump with...

Did the things you describe work prior to the re-wire ?

If you are considering adding additional loads as you mention, chances are the stock wiring of the car needs to be modified as it was designed for the current rating of a stock alternator.

Selling a new design, solid state EL power pack. Item is listed and available on E-Bay. 66-67 Charger EL power pack, NEW solid state design. | eBay

In my 66 Charger I keep a basic " Survival Kit " in the trunk. Luckily, never needed any of the stuff, but figure I'll be able to get it on the road again by covering the most typical issues with these cars. * Basic tools * LED work light * Multi Meter * Spare coil * Spare ballast resistor *...

After going to all the work on your gauges, you definitely want to get the RTE voltage limiter and install it before you put the cluster in your car. The original limiter that is internal to the fuel gauge is the weak link here and it get's disabled as part of installing the RTE unit. If the...

As Don suggested, disconnect the headlamp connectors at the headlamp buckets on either side of radiator and check to see if you are getting voltage at the connector with headlights turned on. The clicking you are hearing could well be the thermal circuit breaker for the headlight motors. That...

Could be just an adjustment... or a bad Neutral safety switch. Don't believe that I read anywhere that you replaced the NSS. You did things to the wire which, if was sorted to ground somehow would be just like bypassing the NSS which provides a ground.

Power antenna ?

Or, just get the correct ones.... Exact Reproduction Spark Plug Wire Sets for Classic & Muscle Cars

Accurate Exhaust. https://www.accurateltd.com System I bought was a perfect fit on my 66 Charger.

Although I don't have a Coronet, I would think that removing the 2 screws on the lens assy. will get you to the bulb. When you get the bulb out inspect it as you may simply have a broken filament internally. Or, you may find some corrosion in the spring loaded socket that needs to be cleaned...

For sale is a NEW modern design "EL" power pack for electroluminescent Mopar instrument clusters. It is a direct replacement for the original factory power packs that have failed due to age. For use in 66-67 Dodge Chargers as well as certain early 60's era Chrysler Imperial and 300 models that...

I only have schematics for my 66 Charger. IF your starter relay and wiring is similar to what was used in a 66 Charger, looking at face of starter relay... with the large heavy lug to the left side, that stud is directly from the battery + (Batt). The center terminal (SOL) terminal goes to...

There is a neutral safety switch in transmission. It creates a path to ground for the starter relay. Must be in park or neutral to crank. Also check for a green corrosion showing at crimp's and at the rear of terminals in connector blocks. The corrosion will make for resistive electrical...