Search results for query: *

Several years ago I got into the left turn lane and this woman pulls out of an apartment parking lot and blocked me in the esplanade. Around here pulling out of parking lot doesn't give you the right away....and I wasn't in the mood so brake stand time! Scared the snot out of her. Y'all reminded...

Amazing right. And he’s an hour away from me. When it’s meant to be, it’s meant to be.

I personally rebuilt the 1972 factory Thermoquad (6139S) after purchasing it used. Now installed on a fresh rebuild which we have just barely broken in the camshaft for twenty minutes. Idle sounds crappy and mixture screws turned in all the way have no effect (nor does unscrewing them). Putting...

Your family's great story is the same story as nearly all immigrants that have come to America, including today. There will always be scammers among us and some will even reach high places in government and society. Immigrants escape to America and generally bring a great work ethic, and later...

I suggest you check with National Moparts in Beaverton Ontario. They have been selling M&H harnesses for years. Then you don’t have any hassle.

I'm trying to piece together the history and VIN of a 1968 Coronet R/T 426 Hemi that I owned in the early 1980's. At that time I wrote down all the broadcast sheet info, but for some reason I left off the full VIN. I'm trying to figure out the plant code so I can get the correct VIN. Were 426...

Here's what I found. PM sent. $40 for the pair plus the ride.

Still looking for any of those parts?

Cleared snow and worked on my ‘58…

They do have baffles. I believe the original part numbers may have been P3549842 left and P3549891 right.

You haven't lived until you install a set of lower buck headers on a b body with a big block. All good info above. All the head holes will need sealant. One thing that helps is to use studs on the front and rear holes, helps for gasket install and helps with the starter being able to swing the...

Still available, I missed Dstan’s message and will watch for messages closer.

My car has already been converted to a A833 4 speed from the original 3 speed. It’s a 440 with bench seat and a hurst shifter with pistol grip. So I am assuming the things you mentioned above have already been done. My question about fitting was mainly tunnel clearance since it came out of a...

Its not the hair,because I still got that look going on,and the chicks still love it!

Sure looks content >

There was a bad diode but I replaced the alternator and ran a test with a good one but still got the same results so I thought I might have the connector on backwards but have not tried with wiring switched