Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
If you are you are building budget behind a 318 from a pick a part. How about a nv3500hd from a Dakota with the 3.54? First. Aisin has some 5 speeds. The r154 needs a bell from an early 90s Dakota with an ax15 trans. Someone had a post I think about a Colorado trans behind a jeep Liberty bell.
Flywheel has to match the bellhousing. Your car is 50 years old. My old 68 RR had an 70s aluminum bell with the 130 wheel because that is what someone put in there.
Do you have a volt/ohm meter
1 if you can jump the solenoid as stated above, thn the start side should be good.
2 the solenoid case needs a good ground to the body.
3 make sure all wire connectors are clean
4 make sure the neutral safety side is to a good ground. Car in Park or neutral of...
If you poured some gas down throttle body to try and start it. I would think that would eliminate the sniper as it's not flooded. I pour a little gas it the carbed cars in the spring so they start with the first crank. Could you try holding you finger it a plug hole to see if you get spark...
There are a number of rollers that can rust to the shafts or break. Go on youtube and search " mopar B body rear window regulator removal" for an idea of the parts.
On a 68 charger, the short ones go on the sides and top. Long one on the bottom. I've heard early build 68s used 67 clips on the bottom which are supposed to be longer than later build 68.
Not familiar with 66. But the yellow with the stamped depression looks like a place for a trim clip to be screwed. The red looks like a gasket retaining tabs.
Depends. I pieced mine together cheap. Sounds like you would be getting spindles with caliper brackets for the slider calipers and the 11 inch rotors. The 11.75 inch rotors backets are ddifferent. Check doctor diff and rock auto for pricing. Look up mopar action "disco tech" article for info on...
1)Will it crank if you jump the starter( car in park, foot on brake) 2) Does the neutral safety switch have a good ground. 3) Is the wire from the transmission grounded when in park and neutral. 4)Is the wire from the ignition switch hot when turned to start.
I put a 440 in a 318 charger . I believe I only changed length for coil a distributor. Put a six pac i 68 RR. I remember having to add a wire thatt was keyed hot for the iidle solenoid.