Search results for query: *

Recently just finished up my 1970 Road Runner project. It has a 383 engine, eddlebrock manifold, Holly 4 barrel Carburetor, purple cam upgrade, headers, turbo walker exhaust, new plugs, wires, starter etc..new fuel system as well. We also put in a rebuilt torqueflight 727 transmission with a...

Amateur here been SLOWLY rebuilding this 70 Road Runner 383 engine and have it running with a new 4160 Holley carb. The car has been reeking of gasoline every time we start it up. Today we (I think successfully) adjusted the floats on the primary bowl of the carb, gas was too high in the bowl so...

Hello, I finally have my 70 Road Runner running well however the oil pressure seems high. The original gauges no longer work so we hooked up a aftermarket mechanical guage where the oil runs through the line to the back of the guage. It consistently shows above 60psi. The oil mark on the...

Hello, I need to swap my fuel tank and clean out the lines due to rust/gunk making it's way through the lines. While I am in the processes of getting that taken car of, I would like to be able to start my car every now and to keep the fluids moving and the car fresh. Is there a good way to start...

Hello, I previously posted about my fuel having gunk in it creating my car to stop running but now I have discovered that my Ignition Coil is leaking oil out the top (discovered when disconnecting the connection and saw it was filled with oil). Doing some research it seems this could be the...

Hello, we have a 1970 Road Runner and thinking about taking it to a shop in the Bay Area California area to have it looked over and tuned up (carb tune up etc..) We did a lot of work on it ourselves and just want to have an expert check it out and make sure it is up to snuff and tune it up a bit...

My Road Runner sat for many years and we finally got it up and running again. It had a few good test runs but the latest test run had the car stuttering to a stop and engine shut down. Looks like it is lack of fuel getting to the engine. We filled up the fuel tank with about 5 gallons of gas and...

So finally got the 70 Road Runner in shape to take around thte block. Crossed fingers everything was going to work and sound well. It did for the first 5 min but then a whining/slight grind noise started. It is not coming from transmission or engine as the noise continued in nuetral and the...

Hello, I have a 1970 Road Runner with a 383 engine. I need to route my spark plug wires nicely off the engine. What are some good wire looms that work well? How do I bolt them to the valve covers? Do I need longer bolts? I did purchase the Mopar universal looms P5007481 but now that i received...

Hello, anyone have any suggestions on a good cheap performance air filter that will fit in the stock housing on a 1970 Plymouth Road Runner 383? I found the aFe Pro Dry S Air Filter Elements 11-10022 but it is rather expensive at $50. Anyone have any thoughts? Thanks!

Hello, I am getting ready to install the driveshaft back in my 1970 Road Runner. Anything I should do before I put it in? Grease? U joint grease? What do you recommend before I just slap it in. Thanks!

Hello, I have a 1970 Road Runner with 383 automatic that came stock with 4 barrel carburetor. Anyone know what gear ratio I have in the rear end? Thanks!

Hello, I bought this CVR 1338 Mini Starter from Summit Racing because the other starter I had was barely touching my headers on the back corner of the main big part. I bought this one to try because says it has 10 clocking positions which I am hoping will give enough clearance from the headers...

Hello, I am missing one trim piece on the passenger side of my 70 Road Runner. It has not turned up in any swap meets. Does anyone know where I can find this one little piece I need for cheap? Thanks!

Hello, I am new to the forum and this is my first post :headbang: I am currently thinking about what carburetor to put in my 1970 Road Runner. The car is pretty stock except some minor changes. Here are my specs: 383 engine Edelbrock performer 383 intake (Part number might be 2186) Mopar...