Search results for query: *

I’m looking for a chrome mirror for the passenger door of my 1972 satellite wagon.

The “emblem” in the center of my 72 satellite wagon is missing. It appears that it was likely a decal? If so, does anyone know where I can buy one?

I’m sure this is a very common issue with these old wagons, but the wood grain on my 1972 satellite wagon is looking ratty. The car is a survivor so I guess I can cut the wood grain some slack since it is 50 plus years old. Is there a source out there for the correct wood grain decals so the...

I’m trouble shooting the fuel sending unit on my 1972 satellite station wagon. I have it on the bench and it reads 11 ohms at full, and 80 ohms at empty. I’m not sure if these sending units are different from the wagon vs the car since the tank is oriented differently, or that the wagon gets a...

When I recently bought my 72 satellite wagon, the previous owner had replaced the wiper blades with modern replacements, and they were too “high” and would hang up on the edge of the hood and not bed properly below the hood. I went to Napa and ordered up replacements and the ones that came up...

So a strange question, but the license plate light assembly out of my 1972 satellite wagon was in the glove box when I bought it. I played around with installing it tonight with the 2 screws upward into the top part of the bumper above the license plate, but it doesn’t seem to fit right. Can...

I’m still waiting for the shop manual to arrive for my 1972 satellite wagon I recently bought. The horns are not working and the previous owner said the horns haven’t worked in years. Tomorrow I’m going to start trouble the horns and repair them. Can anyone tell me where the horn relay is...

Starting to clean up the survivor 1972 satellite wagon I picked up last week. I noticed there is an emblem missing in the middle of the steering wheel; what emblem would have been there originally? I’ll need to track one down!

So I’ve restored the steel front grille mounting surround from my 69 charger, and the next step will be to restore the plastic grille itself that mounts back into the steel frame. I’m looking for hints or tips on things like how to go about removing the fasteners that hold the stainless trim...

Wrapping up the restoration of the dash from my 69 charger while it’s out of the car. When I bought the car the glovebox was open and wouldn’t stay closed but I didn’t care as the car is getting a full resto. Now that I’m finishing the dash, I do care and I can’t get the glovebox to latch. The...

I’m restoring the dash out of my mostly survivor 1969 charger. Mounted to the bottom of the dash is this speaker switch which is basically a rheostat, so I’m guessing it’s a fader switch? My car does have rear speakers but they are round so I’m assuming they are not originals. Is this switch...

I’m in the middle of restoring my plain Jane 318 69 charger car, as well as the dash. The dash “medallion” that goes at the top of the dash between the tic tic tac and the speedo is long gone from my car. I see there are a couple of options out there that are referred to as “early” or “late”...

I’m looking for a thumb wheel dash dimmer switch for my 1969 charger. My original is missing a few times that had corroded and broke off

I’m restoring the dash out of my 69 charger, and I’m just about to paint the black plastic radio bezel. I’m looking at the letters on the bezel (vol, tune, on, off, tone) and I can’t tell if the raised letters should be white or silver as the bezel is in need of freshening up. My guess is that...

So I am tire shopping for my 69 charger that I am restoring. I am keeping the car stone stock and I am about to restore its magnum 500 rims. In keeping with the original slash stock theme I am looking at putting white line tires back on the car, which is what it had from the factory. I’m looking...

The black plastic decorative dash piece that goes above the glovebox on my 69 charger has a warp in it out towards the drivers side end. Other than that, the piece is good and re useable. Does anyone have any suggestions on how to straighten it back up? I was debating very carefully warming the...

I’m restoring the dash out of my 69 charger, and I’m at the point of wanting to refresh the black plastic pieces including the gauge cluster piece. Can anyone tell me what sheen of black paint would be factory correct on these plastic dash pieces?

I am restoring the front grille on my 69 charger, and I have been testing my headlight door vacuum actuators with a vacuum pump. My drivers side actuator is not working. Is it possible to rebuild these things? Also, my passenger side actuator has a bend in the end of the arm, while my drivers...

Has anyone on the forum built one of those stands like you see on graveyard carz and other sows where you can have the engine, k member, transmission and most of the front suspension on a stand so that you can move it under the car and drop the car down onto it? I’d like to build one, and some...

first I should give a bit of history on why I’m asking thee questions; I’m a Mopar guy who has restored a 66 Coronet 500, 69 d100, 70 d100, and a 68 charger (which I never should have sold!). I’m looking at getting into another Mopar muscle car and I’ve found an intriguing 71 road runner...