Search results for query: *

Getting ready to do quarters on my 72 charger so I need to place the deck lid on so I get the alignment correct. The problem is I cannot get the decklid to align even to the old quarters. When I purchased the car the trunk had been broken into, the deck lid had been destroyed and the trunk...

I started removing the 1972 Charger rear quarter for replacement. It is pretty obvious that I am going to need an outer wheelhouse. My concern is the rotted area under the quarter in front of the wheel well. Is this part of the rocker? I see they sell rockers but am unsure if they come all...

I need a strut rod for 1972 Charger. Just realized One of mine is bent.

Hey Guys The hood that came with my 72 Charger had a pro stock hood scoop on it. I have picked up another flat hood but would eventually like something different. I picked up a 73 Roadrunner hood for $75 which I thought was a good deal. I know I could attempt to graft the hood scoop onto my...

Working on my lifetime project. Ready to tackle the body rot by the lower door hinges and rocker. Can anyone tell me if there is a patch available as I am assuming this is a common problem. Does anyone know if the replacement rocker panels go all the way to the front as mine are also a little...

Does anyone know if an 8 3/4 rear end with a 489 case use an oil slinger. I am rebuilding mine and there was not one there when disassembled but just wanted to make sure. Thanks to anyone who responds. Mark

I have a 72 big block charger with a manual transmission. The engine is no good and have purchased 2 blocks which have both measured unusable. Was thinking of going to a 360 motor from a later model truck. Has anybody done this swap. My concerns are VSS, pilot bushing, bell housing, OBDII...

I am a new member to the forum and the recent owner of a 72 Charger with a 1970 383 and 4 speed manual transmission. I have pulled the engine which is undergoing a rebuild and have come across an A body overdrive unit for short money. I was looking for input into what is involved in placing...