Search results for query: *

Clutch type LSD 1-11/16" on the carrier and 489 case 3-1/4" OD on the race.

Working on a 69 b-body with a 489 center section cone limited slip. Housing is 55" axles are both just shy of 29 1/2" flange to the end. One and maybe both axles are barely engaging the inner splines of the center section. You can see in the picture it buzzed off the end of the splines on a test...

New or good used, mine are pretty rough. PM me. Thanks

Has anyone used the Essex (cut pile) with Mass mat, if so do you like it and was it easy to work with?

These things have the blue plastic protective coat on them and must be old, it peals off in tiny pieces. Is there something I could soak them in to loosen it up?

Looking for a nice one no pits or peppering, I have one like that already. Thanks PM me

Others may fit I don't know. 7 1/8" long. PM me thank you

I purchased a set for a 69 charger and this came with it. Where does it go? A picture would help! Thanks for any help.

Nice one $35 plus the trip

Above the pan is dry but the pan gasket is wet and trans oil dripping off some of the pan bolts. Is it just a pan gasket or are there any pan bolts into the fluid or all blind holes?

My daughter insists on 18's. Maybe a 7" front wheel 10" rear and what size tire works without clearance issues?

My daughter 69 Charger has Right Stuff 4 wheel disc brakes on it. No complaints they work well, but I'm wondering what over the counter parts could be used for maintenance in the future such as pads and rotors calipers? Year, make ,model of cars.

I need a pair of housing driver or better. In AZ 85308. PM Me

New 2.65 30T 2nd gear, 1st-2nd Synchronizer assembly, All new synchro rings, new 3rd 4th shift fork, new bearing and seal kit and reverse switch. 1970 main case 1969 tail housing. $2500 plus shipping. Located in Glendale AZ 85308 PM me Bob

Am I right in my thinking the only place the long clips go is below the windshield? The sides, top and all the rear glass uses the short clips?

Is there a trick or is the OER brand grommet as bad as their other stuff. Ive lubed it up jumped in the trunk and gave er all I got, just wont go in?????????

Found some Thanks

Need a nice one not warped, I can paint if needed

The hockey stick shaped piece from the radio over the glove box.

The metal shield behind the lens that surrounds the instruments