Search results for query: *

So a few weeks ago I asked about the type of nuts that attached the console lid to the hinge. I was able to purchase the correct nuts but they don’t seem to tighten very well. As a result the lid doesn’t seem to fit correctly. Any tricks to this? I can push down on the lid when it is closed...

I am replacing my convertible top cylinders on my 67 Coronet. I removed the “mounting plate” and pulled the little pin that retains the ram to the top mechanism, but what is the trick to removing that ram eyelet from the pin? It does not feel like a nut on the back and the “pin” just seems to...

As you may be able to tell from the multiple requests, I am putting the interior in my 67 convertible. Would anyone have close up pictures of where the rear interior panels attach? I am hoping to get detailed pictures on screw placement along the top as well as at the bottom where it meets the...

Would anyone have a picture of the hardware used to attach the console lid to the hinge? My car was in pieces and I can't see to find what kind of nuts are used as the studs on the lid itself don't seem to be threaded in the traditional way. I would appreciate it.

Hi All, I recently purchase a 67 Coronet Convertible that was transformed into an R/T tribute. It has a 440 / 4sp. It has a Hurst shifter for the 4 speed but it is very vague and notchy when shifting. I would like to find a shifter rebuild kit. What will I need to know in order to get the...

I have a 67 R/T Tribute convertible. I would like to figure a way to add rear speakers. Previous owner had cut 6x9s into the convertible interior rear side panels (as you know - these side panels are like hens teeth). I found a really nice uncut set of side panels and do NOT want to cut them...

I have the interior trim pieces that say "Coronet R/T" to mount to the interior metal part of the door. Can anyone tell me what type of screws are used to affix these to the door? I am sure I could use 3M tape, but they will still have the open screw holes. Pictures would be appreciated...

I would like to refinish the metal part at the top of the doors in my 67 Coronet. They are black. Does anyone have any paint (type / finish) recommendations?

I need to install the stainless rocker trim on my 67 R/T clone. I Have the upper trim clips, but what screws are used to attach the bottom of the rocker trim? It doesn't look like Classic Industries sells them. Thanks!

What is the best way to clean / polish these trim pieces? I have a buffing wheel and various compounds, but are these pieces anodized? What is the best way to polish them up before install? Thanks all!

I am looking to purchase two of the inside door emblems pictured below

I seem to be missing these. Is anyone aware of any repops being produced or have a lead on a set (drivers and passenger door emblems needed)

Hi there. Just purchased my 1st ever Mopar. It’s a 1967 Dodge Coronet R/T convertible tribute. According to the VIN it started as a Coronet 500. It has a 440 and 4 speed. Exterior has already been done, just needs the interior done now. Hoping to find some parts, knowledge and comraderie here on...