Search results for query: *

Timing 15 degrees advanced but will check it .

Holley says bump up air Bleeder screws on 4 corners 3 sizes reajust idle mixer screws then put in power valve after highest vacuum reading leave #32 squirted nozzles on should cure it

I'll try 3.5 today and get different jets

440 425 hp. 833 4 speed Dana 60 354

Bought new 4150 hp 850 double pumper replaced old one same carb just older. Installed it dialed it inane set floats. getting bog when slamming gas Holley told me go higher squirter nozzles did that. didn't do it then they told me it has 6.5 power valve in it. It has a 4.5 in it. so I bought a...

Thank u everybody grounding issue

I'm thinking distributor but I don't no how much play it suppose to have right now u can move shaft about 1/8 inch

Yes I'm using a ballast resistor the ballast resistor and all other electrical parts were change two years ago we replaced carb last week still all dialed in and timed .start running shitty high speed the backfiring coil was junk replaced it car ran fine went for a ride yesterday same thing took...

my 440 seems to be eating coils 2 one replaced took distributor cap . Put new carb. On it backfires . Check timing ok and coils gone happened twice. Took cap off I have electronic ignition rotor seems to be rubbing metal brass contacts on cap . Wondering if I need new distributor .

K thank u

I got dual contact single filliment in there bulbs fine when u hit brakes dome light an map light come on no brake light on tail light when u hit brake when doors are shut I got power to dome light . This happened all of a sudden the other night. Only thing I've done is replace coil. Some weird...

Also when u hit brakes dome light an map light come on no brake lights in back

Map light goes on off when u open an close doors with ignition on u put emergency flashers on map en dome light blink

got in gtx tonight dome light wants to stay on with doors shut map light on also when u take bulb out of dome light map shuts off and map light works fine any help thank u

Ok thank u - - - Updated - - - Did u go with ceramic coat or did u paint them

Looking to put new headers in 68 gtx looking into patriot headers anybody have these on b body .also how do they fit they look like hooker comp headers .

Looking for headers for my 68 gtx wondering if anyone has patriot headers . And how do they fit .

Car has 440 with solid motor mount on drivers side rubber on passenger side rebuilt transmission car jumps out of second gear before rebuilt it never did. shifting from second to third revving around 3500 tranny feels like it's coming up threw floor wondering if my tranny mounts bad any way to...

Thank u

K thank u