Search results for query: *

Thanks everybody, Looks like I can install my my headliner.

Can you confirm 2 springs on the back bow?

Thanks everyone, I got the parts I needed from Big Bill.

Must be the rectangle one.

Need the dome light assembly (bracket/bulb, socket & wiring harness. for a 2 door or 4 door sedan. It the rectangle one.

VANDAN, Just the photos I needed. Thank You !! I looked thru all my parts boxes and can't find this socket & its wiring harness.

Ok, I have a rectangle bezel/cover that matches the screw holes in the car roof. I'm missing the light bulb socket and wiring harness. Not sure how the bulb socket attaches to the car. Attached photo is what my dome light bracket looks like. Anyone have a photo of the light socket assembly...

That's a hardtop. I have a spare set of those along with its wiring harness, But I have a sedan. I found a rectangle lens, but no housing which I believe is for my sedan. I'm restoring a basket case sedan and I'm missing some parts.

I'm gathering parts for installing my headliner. What style shape is the dome light?, Round, Rectangle? Did Sedans have a dome light. Anyone have a photo.

Gathering up parts for installing my headliner. 1) What position do they get installed at? My hardtop was the shortest in front and longest in rear. Is a Sedan the same? 2) My hardtop had a spring on the back bow. Don't remember is there was one or two. Is the sedan the same? 3) My...

I need the headliner sail panels for my 1965 dodge Coronet 2 door sedan. I can't find anyone who sells them. Hardtop ones are readily available. If someone could send me a pattern. I could make them. Don

I don't have anything like those on either of my 65 dodges, sedan and hardtop.

They go just inside the top front windshield. The top inside window trim screws into them. There are 4 of them. They are made of hardened steel and have two pinch tabs that go onto a hole along the top inside front roof. There is no no screw for attaching them to the body, just those tiny tabs...

I bought a 65 Coronet that looked just like the front end of this car. I thought it was an easy repair. Just replace bumper grill and lower radiator support. After digging into it found: Both front frame rails bent inward. Was able to pull out side out. The other side I had to replace the...

Still looking. I think 1-1/2 is a little excessive. That what I have on one of mine.

Still need one Good Spindle.

jimbosride, Looks like some wear on the inboard bearing area. Also a grove in the seal area. What does the other one look like.

I only need one. Can you post better phot0s of the bearing and seal areas.

Yes, it is the same. must be for drum brakes. It has a 1.250" inner bearing. Must have no rust on the spindle shaft and good bearing and seal surfaces. PM sent

Jerry, No hurry, just want a good one. I already have a bad one. Enjoy the Holiday weekend