Search results for query: *

I'm installing a 340 auto trans. Checking the degree angle down front to rear, what is the norm and what are the limits up and down with side toe side at 0*? Thanks ron

How do you identify the different backing plates and the size brake lining and drum size they need?

What problems would I encounter by swapping a newer 5 speed (2000 and newer) out of a V8 truck onto a 1968 318? Will everything bolt up and mate? Putting this setup into a 1953 Studebaker, hoping to use the peddles and Hydraulic clutch. Thank ron

Is there a difference in Hydraulic lifters between Big blocks and Small Blocks? I ask because Napa calls for the same lifter for 440 and 318's and a different number for a 383. Please explain Ron

Looking to find a headlight switch for my sons 1970 Dodge Coronet Super Bee. Summit SW is back ordered till September, others want to sale a kit of all three switches foot dimmer, instrument dimmer and headlight switch.

Our 1970 Dodge Super Bee power brake booster has just sprung a leak. Brakes are hard and takes both feet to stop. Who ha replacement booster ready to bolt in?

Which is the front of the wing? Is the straight edge toward the front and the angled edge in the rear? The straight edge is thicker than the edge with the angled tips. Pic's would be nice if someone has any that are correct. Thanks ron

Is anyone still making an adapter terminals to use these starters on a big block? I think the starter I have is for a 1995 truck.

What is everyone using to paint there engines street hemi orange. Has anyone used Eastwoods ceramic Chrysler orange engine paint?

Does anyone have pic's of a 383-4bbl with a/c of the engine compartment that has not been altered and is original?

Is their anyone who reproduces ........... Factory Tach for 1970 Dodge Super Bee? Thank you

Does anyone reproduce heat oven for this manifold?

My son just purchased a 70 Bee. Everything is there but the 383. He found a 70 383, is there a matching vin on the 70's, 383's and where?

Can anyone tell me what the compression was for a 1976 400 out of a charger? And what low cost bolt-on or cam what help in raising the performance?l

What roller cam and lifter Pkg is everyone using in their Street Big Blocks?

Anyone making these lower control arms?

Looking to install a remote oil breather system on my big block. Not sure of what to use. Can I see some pic of some options?

Trying to get all the angles right. Starting with Engine,Trans down angle if car is level. What is the range from good to bad and ideal?

What are the two u-joints used in the 60's and 70's and there measurements?

Are the disc brake spindles the same for the slider type calipers as the pin type calipers? The only difference being the caliper brackets bolted to the spindle!