• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  • Users: Cafar
  • Order by date
  1. C

    Wrist pin stock rods issue, too loose?

    Reading your tips I will do as follows, measure with proper gauge old pins and new ones, as well as rods. If clearance is -0.001 I will apply press fit. So far I did not heat any rod 69Bee Thanks.
  2. C

    Wrist pin stock rods issue, too loose?

    Two pins pressed out, the same situation for both, manualy I can put it in rods. I would prefer to press in new ones rather floating, last option. Can you support me in press out good practise? Below piston picture with cirlclip on 236, am I right?
  3. C

    Wrist pin stock rods issue, too loose?

    I did hot heat up rod before press out, is that necessary?
  4. C

    Wrist pin stock rods issue, too loose?

    Thanks guys for quick reply. I,m going to do it for the first time.Curently preparing stuff and myself to insert new pin and pistons. I've been watching YouTube instruction: heating device for rods, fixing plate for pistons etc. Month ago I pressed pin out, i did it with hydraulic press, no...
  5. C

    Wrist pin stock rods issue, too loose?

    Hi, I want to replace stock piston 440 '76, with kB 236. I removed wrist pins with help of press, now I'm going to press in new ones. It seems that pins are quite loose in the rods, i can insert them almost manuały. The old pins are the same. Stock pins are press fit style like the new that came...
  6. C

    Rod bearing 440

    Thanks for quick reply and hints. The story is i want do assembly by myself, so far the set is as follows 452 heads with kb 236 0.040, cam xe274, edelbrok rpm, carb i dont now yet.all bearing, gasket new. You right best way is to ask machinist for measurement. But anyhow i will check check crank.
  7. C

    Rod bearing 440

    Hi, in a short, restoring 318 Charger 66 and go to swap 440 76. Actualy 440 engine teardown and block is geting bored and honed. I want to order rod bearing but i have no clue whether undersized or over. There is no maltese cross neither other sign. On stock bearing i see AT 10 does it mean...
Back
Top