Search results for query: *

I had to sell my 66 - and had acquired a center console that I never got around to installing. I still have the parts, but it is disassembled, bagged, and labeled. I am asking $250. I will ship it but it will add cost. I am in the Minneapolis area... Here is are the details of the packed and...

I had to sell my '66 but still have the center console, shifter, mounting brackets, wiring etc. I am asking $250.00 for the setup... I am in the Minneapolis area and will ship, but that will add cost.

Here the car running See all pics on my craig's list ad The car is located in Oak Grove, MN. I have had this car since 1996 and am looking to sell for a down payment on a cabin, my how priorities change. This car is a lot of fun to drive, with a 3500 stall and 391 with posi, 727 transmissions...

Selling a fully functional\upholstered front benchseat out of my 1966 Belvedere II. This will fit 1966 -67... From looking at other posts it sounds like it fits in up through 1970. $200.00 Plus shipping. This would ship from Minneapolis MN

I am selling the rear bench top and rear valance deck. $225.00 + shipping this is being sold as a set. Dimensions wise this will fit into 1966 B-Body's which is what I had intended but getting stuff ready for upholstery I changed my mind at the last minute. It would be shipped from Minneapolis MN

I had swapped out the bench for some buckets out of another '67 Belv. In my haste to get them torn down and restored... I did not stop to get any pics of the tracks and how the connect or left\right side. Can anyone point me to some good pics our instructions for the track assembly?

I bought the lokar kickdown cable (kd-2727ht) & the xsrk-4000 (bracket and spring) for my 66 Belvedere II 383 / 727 3spd. However I don't have the kickdown lever. I called a local tranny shop and they said they have a 3" lever that will work but he said my cable may not work and that it is...

After fixing other issues with my Belvedere II... I need to replace the fuel sending wire. I have measured the resistance at the tank and it reads correct, but the wire is shot. I have looked at painless, and a few other sites and I have been unable to locate anyone that sells the wire (from...

I have a 1966 Plymouth Belveder II, I am in the process of converting the upper portion of the back bench seat and addding the fiberglass surround. However when I purchased the fiberglass surround it does not fit quite as expected, so I am wondering if the 1966\67 rear dash is different or if I...

I replaced my headlamp switch to fix an issue with my dash lights not working, and as long as I pulled my dash out I ordered I also replaced my voltage regulator, becuase my fuel gauge was not reading correctly. After the re-assembly my accessory lights & blinkers work but my temp gauge and...

I am looking for the upper portion of the seat, and the cap that goes around the rear bench. I believe the parts for the 66 & 67 b-body are interchangable, and I would be installing into a 66 Belvedere II. It would look like this:

I reviewed 3 other threads about dash light issues, but they don't match my issues. A little background... I replaced the switch that powers the lights on my car, because my headlights stopped working, but prior to that my dash lights stopped working. After replacing the headlight...

I have a 1966 plymouth belvedere II and I am looking for the rear seat... upper back and the cap around the seat. The parts would look like this http://s926.photobucket.com/albums/ad110/dcatcha/?action=view&current=rearseat.jpg I believe the b-bodies for the 1966 and 67 satellite...