Search results for query: *

Yeah prob not. I’ll double check tho.

What would be the best glue or epoxy to adhere this plastic bulb casing to the aluminum housing on a Rallye dash? This is on a 69 Bee. The company that restored it evidently didn’t use what was needed to create a good bond, two of them have come loose. TIA

Don't feel stupid. Others don't know either, including me.

You can send pm

Ok. Thanks. $$?

Have you tested it? Does it work, or can be made to work? Thx

Have been having problems with USPS lately getting anything on time. Purchased a rear tail panel from a member here and it was shipped April 1. Has been stuck per the attached pic for about a week. I’m getting concerned that it is lost. I have a terrific lady mail carrier who is helping me...

Pic from the internet. I have the bracket and part of the switch but the plunger was missing. Need for my 69 Bee. I mistakenly bought a switch off eBay that was for the wrong purpose, should have looked more carefully. Pic of that and part number attached if anyone needs it Pic 1 - what I...

The heater core was replaced but not yet installed. I do agree that I should take the radiator to a shop. Now about the block…. lol

I have a similar issue and need to drain / flush. I am in the process of restoration and before I purchased the car (69Bee, 383) the engine was rebuilt. I had noticed that the water is very rusty and this was concerning, however during the restoration and pulling the Heat/AC box I realized the...

Nice to see these old cars in great condition and well documented. A real treasure!

Yes I have both. Thanks. I ordered an entire kit from DM some time back and forgot that I had it. I have all the pieces of that puzzle now thanks to the good advice on this forum.

Can't tell by the pics but did you strip the anodizing and then polish or paint the aluminum? It does look good.

true that!

now it is $50 and $100 to death, and then some.. your post cleared things up for me, I sourced that part on Ebay and ordered it, about $40 with shipping....there were some of the same thing on there for $100 plus many thanks for the help! Got all those parts now....I think lol

Thanks. I'll look into sourcing that part.

Very sloppy, that is what is throwing me off...

I think I have one. I’ll check it out. Thanks.

I do not. How would the round end hook up? Both ends I have are rectangle. Am I looking at this wrong? Thank you for your input!

1969 Dodge Super Bee w/ factory air… See pic….Is there a flex duct that goes between these in the middle ac vent (Rallye dash)? If so where could I source? I have new duct for the end vents, could buy online. Have not seen what would bridge the gap here. TIA.