Search results for query: *

So I installed my steering wheel column to ensure I had all the parts and for fitment. However, the steering wheel is just too close to my chest and my elbows bent to far as well. I've double checked the seat rails, they move freely and all the way forward and back. I've attached several...

Can you use a vented gas cap instead of adding the vent lines to the tank? I thank you all in advance, Ed

I installed the following 4 wheel Disc Brake Conversion Kit. The Right Stuff 1962-72 Mopar B/E-Body, 8" Booster, 4-Wheel Power Disc Brake Conversion Kit - (MDC42DC-P) I purchased the following rear wheel rims. https://www.classicindustries.com/shop/all-years/dodge/coronet/parts/?q=MW860 I am...

I received my leaf springs for my 1970 Bee however, one side has 7 leafs springs while the other has only four. I checked my originals ones and both have five. The car was an original 3.23 open diff however, now it is an 3.55 posi. Can somebody help? I thank you all in advance, Ed

I've been restoring my 70 Bee for about ten months. Here are some pics of the build progress. Additionally, I would to say thank you to all of you for your help. It has definitely helped during the build.

Does the 1970 Coronet R/T trunk lid fit on a 1970 Coronet Superbee?

I need to buy a trunk lid for my bee however, I notice a difference on two of them on eBay. Underneath one of them has a hump in the middle and the other doesn't. Which is the one for a Superbee.

I bought some seal power pistons and my ratio should be 9.5:1 however, my ratio is around 7:1. The pistons are not coming all the way up (Short about 1/8 inch). Can somebody tell me exactly where to purchase an OER set of piston? I thank all of you guys in advance, Ed

I'm restoring my 70 Bee and need a wiring harness. Every wire for the entire car from the front to the back. The prices are all over the place and as high as a $1,000 for supposing a full harness which you can and other stuff as well (A/C, cruise, etc.). Any help would be greatly appreciated.

What would be the best CFM Carburetor for the below setup? I have a 70 Bee with a 383 CID. https://www.jegs.com/i/Edelbrock/350/2086/10002/-1

Hi everyone, Looking for measurements and specifications to ensure my 70 Bee is square. Replacing floor pan, trunk pan and extensions, both quarters, and all metal around lower rear window. I will be bracing the car where necessary. I know my car is not straight because it was in an accident...

I will like to say first, thank you for all the help you guys have provided me. I purchase a Edelbrock 2086 TOP END KIT which will produce 421 HP with 417 Torque. Additionally, I purchased from Silver Sport Transmission an A41 Automatic 4 Speed transmission. I would like to know which diff...

Where can I find the specifications (Measurements) when installing body panels on a 70 Superbee? I'm replacing the trunk pan, trunk extensions, both rear quarters, both door jam lock pillars, front part of floor pan, deck filler panel, and corner patches on both side of rear window. I know it's...

Thank you very much for letting me join. My name is Ed and I'm restoring a 70 Superbee, 383, 4 barrel, 3 Speed, with an Auto. Have an AWESOME DAY!