Search results for query: *

Thanks for the information. I believe I was able to modify the one I had to make it work.

Hello, I'm searching for a torque shaft that would have been used on a 66-70 B Body console automatic car. I have attached a couple of pictures of the shaft I need. I know they sell new aftermarket ones in the complete linkage kit but I have everything except it. Thanks for any help.

Message sent

I'm in need of one of the bolts that holds the quarter window to the regulator. This particular bolt has a special shaped washer that goes against the glass. I just need one of them. Pictures attached for reference. Thanks!

Hello I am searching for a few parts I need to get my 68 GTX project back together. The following is a list of what I need: - 2 headliner bow clips - 1 k frame bolt - Set of the stainless trim rings that go around the headlights Please pm me if you have any of these parts. Thanks!

Thanks everyone for the input and I'd like to see some up close pictures also if you don't mind.

I'm trying to figure out what color the grille needs to be on my 68 GTX project. Some of the pictures I see show the grille being black and others show it more of an argent silver color. Can anyone provide any insight as to what is correct or were both used during that year? Thanks for any help.

Pm sent

I'm searching for the passenger side front well well trim for a 68 GTX. Thanks!

Yea I seen they made new reproduction ones but I wasn't sure of the fit and quality. I may have to go that route though. Thanks.

Yea I need the wheel lip molding. After seeing that picture those wouldn't work because the GTX ones cover the entire area and don't stop at the molding like those do. Thanks for the picture.

Do you know what kind of car they came off of? Classic Industries show 68-70 Plymouth being the same with the exception of the 69 GTX ones being different. If the ones you have are off a Roadrunner or Satellite they might work..

We had this same setup in a 69 Charger and had to pull the transmission three different times because the car would not go in gear after driving it. Have someone push down the pedal and check the clearance between the disc and the floater plate. If it is to tight it will not let the clutch fully...

Looking to find a set of stainless wheel well molding for a 68 GTX. I need both the left and right rear pieces. Thanks

Thanks everyone for the replies and information. After doing some more digging I found the latch panel under some other parts. However it looks like I am going to need all the parts that bolt to it. Does anyone know for sure if the release handle and latch are GTX specific? I did read somewhere...

Hello I'm looking for the cross bar piece that the grill and hood latch bolts too on a 68 GTX. From what I've read this piece is 68 specific and the 69 one is different. I also need the spring, latch, and release handle if anyone happens to have those as well. Thanks in advance