Search results for query: *

I do have my exhaust heat riser welded to open position

For give me, I'm not familiar crossover. can you provide more detail on it?

I have connected all the vacuum lines. I have not had the high idle issue . Not sure if that is why. **The next problem I have is I installed a new heat choke thermostat. Coil sits in below the intake cup held by two small bolts. With engine being cold, 75* The center carburetor butterfly is...

Was wondering do they sell a electric chock or a manual choke for the 6 pack set up?

thanks a bunch

Here is my super bee 440 6 pack set up Do I have the vacuum lines correct? Where does the line from vacuum port top middle carburetor go to?

Just a update on high idle issue sprayed some cast blast (see photo) Bent metal up very very little (see photo) Plastic piece was sticking while moving by hand. I adjusted the thermostat spring so that the center carburetor butterfly remains open all the time. QUESTION Also I have two center...

Thank you very much

Does anyone have have a detail of all vacuum line as where they go for the 440 6 pack Or know who can provide one?

########################## Do you have a detail of all vacuum line as where they go? Or know who can provide

———————————————————- The outboard carburetors and rods are installed How do you adjust the choke spring?

I disconnected the two out board caborator rods. This seemed the fix the high idle. I want to put more time on the car before declaring the fast idle tbeing fixed I’m having a choke issue. When engine is cold 40 degree choke butterfly it is closed. I ran the car for 10-15 minutes. I let the...

************************************ I did try that’s screw and got no change in RPM’s

Here is couple of pictures —————————————————————— Yes don I do have the choke and high idle can I wasn’t sure what that was

Yes it has a choke no on the fast idle cam

Hello folks need little help. I have a 440 6 pack question. Little back round,all carborators were rebuilt. Engine totally rebuilt. Now ,the engine has about 40 minutes total run time during engine break in the RPM was was around 1500 At that time the timing was at 0 degrees. So the next day I...

thanks

When getting on the gas. What triggers the two outter carborators to open up?

thanks to you both

When I move the throttle ( give gas) the linkage that connects the 3 carburetors together does not move. It travels through is the linkage connected wrong?