Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
There's this ritual:
Crank for about 10 sec.
Press pedal to the floor (choke) and release
crank for another 10 seconds... and it starts!
Eliminate first step......
Carefully pop out the Bird in the center. There is a locating tab on it. be careful. Pry out near the "BEEP BEEP" Then take out the bolt under neath and there are three Phillips screw in the horn button,,,,,
Thanks for that info, I read through all the paperwork that came with this new stereo and that info was not printed anywhere. So how can you make a decision if the necessary data isn't supplied with the unit, or as with this unit apparently incomplete? Does 50 watt X 4 mean the total output of...
I have a new aftermarket stereo (Stereo) I am wanting to install but cannot decide on speakers for my 69RR. I am not looking to rock the neighborhood when I drive down the street, but I do want a clean clear sound when I get on the highway and crank her up. I see speakers priced at $30.00 a pair...
Think of a circuit board as a wire loom, it routs power to the gauges and lights, only the wires are flat and bonded to a board. Use a continuity tester to check if each circuit is complete...PS look for burns or breaks in the circuits....
The picture below is, I think, the two circuit boards you have. The ground for this type of circuit board is accomplished by the screws that hold the circuit board to the metal gauge housing and the housing then grounds by screwing it into the metal dash frame. follow the circuit and note the...
I need a turn signal switch for my "69 RR. I have read a lot on here and there seems to be a lot of repop crap out there, Can any one verify which one is the best (or least crappy?). I am considering one from Dan Stern but his does not have the lane change feature,,, I read how to modify one to...
You will find an orange wire under the dash, this is the instrument cluster lamps and will dim with the switch. There is a three wire a connector in the center part of the dash that takes a bullet connector. Consult your service manual,,,,
How are you cranking?,,, Sounds like you are turning on key and jumping relay? check for voltage at coil and ballast resistor. Run a jumper from bat to pos. coil term....All you have in column is turn signals and horn, nothing in there to stop it from starting.