Search results for query: *

Floats are set. Needles and seats are fine. The fuel is boiling off out of the carb after shutdown because it is too hot.

Gentlemen, I'm putting a phenolic spacer under my edelbrock carb on an RPM manifold to help with the fuel boiling issue and I'm trying to determine if an open or 4-hole is appropriate for my application. The engine is a mild 360, street car no racing. Its a low-compression, stoplight-to...

Well I am assembling what I need to make the new line, I have 1/4" tubing and am getting the 6an to 1/4 tubing adapter to plug the edelbrock carb adapter up. Im having trouble sourcing the adapter fitting to thread into the fuel pump for 1/4" steel tubing. A 90degree elbow would simplify the...

Whats wrong with the plastic one? I like to see the fuel moving. Glass would probably be better, but the plastic has worked fine so far. Heat issue?

Well I'm in luck, Dad has the flaring tool and good rigid tubing cutter, just need to buy a bender and some hard line.

That's what I was afraid of, really didn't want to have to buy a tubing cutter, hand bender, and flaring tool that I will likely never use again.

Gentlemen, On my 360, I have an edelbrock carb on a performer rpm intake, it has the little l-extension fuel line coming off the carb that terminates to a filter. I'm trying to find a hard line that will thread directly from the end of this filter and run down to my mechanical pump. Where can i...