Search results for query: *

Missed your reply so I'm sorry about, I have change all lighting except headlights to led and everything is working fine. Even installed a custom instrument cluster which uses led.

Problem has been solved however I don't know which of the two changes I made did the trick. Removed the bulb but it didn't feel right coming out so I reseated it then I cleaned up the ground surfaces and it worked properly. My guess it was reseating the bulb but I know poor grounds can do...

Will be working on the wiring Tomorrow. Thx Jim

All sockets in the tail were replaced along with the wiring. Side markers and fender signals were shaved but the front sockets are still original so I'll take a closer look. Appreciate the suggestion. BTW did you have a similar problem and did you found it was an alignment problem?

Just converted over to a custom instrument panel and everything is working fine except my drivers side turn signal indicator comes on solid when the lights are on, be it in the running lights position or headlights position. All lighting on the new panel is LED. When the light switch is off...

Okay,took your advice and got a LED Flasher reply CF12-ANL01 for $6.50 and installed it and it solved my problems. Oh, I DID have to reverse the leads. Just made a couple of short spade connector wires. Now will do the same for my emergency flasher circuit. THX I.B.Sorgn

No - I take it that is required when you move to FED?

OKay guys great info thank you all very much. I have to rewire and replace all the bulb sockets for the tail and backup lights so I will make sure I stay with conventional sockets and wiring.

Can you give me the logic behind your bad ground theory? Any particular circuit? - - - Updated - - - I thought that it might be that the LEDs are not creating enough of a load for the relay to work properly. Any particular circuit that I should take a hard look at?

When I turn my lights on whether it is parking or headlights my temp and fuel gauges will change to higher levels. If I have a directional signal on it will stop flashing if I turn the lights to either parking or headlights. I have swapped out all my 1157 type incandescent bulbs for 1157 LED...

Appreciate the info. Tapped the harness at the steering column and all is well. The old switch is just getting loose and hoping this will save a little ware also, I kind of like the push button start.

Been reading through the posts concerning installing a push button starter switch but I was unable to find one that described the details of the install. Anyone out there install this type of a switch that can recall the process? I have a 72 Plymouth Satellite. Would also like to find a...