Search results for query: *

they find their own level...no need to fill it to the brim...to rob a coffee comercial

take out the rear seat...my grandson squeezed through...I now have 3 sets on 3 different key rings

I got the best response at 5400..anything past was a waste of time for the power generated

would need tire size to compute speed at rpm

650 on that motor and it will run better and faster...750+ is far too oversized

X or H pipe is not going to quiet the exhaust..it just balances pressure...X is the better of the two for balance

firewall and there is a bracket under the column(usually a ground strap attached) that also needs to be loose to lower the column enough. Start with the column part and see if it comes down enough...most likely will have to loosen the bolts at the bottom of the column at the firewall also. Good luck

what year ? My 67 and 69 B bodies only required the steering column be lowered,not removed. That can be done by loosening floor bolts and the column connection to dash frame. Disconnect battery !!...67 B bodies the radio and heater controls also must come out. 68 on up, they stay in but the...

I run 391's with 27 inch tall tires....3200 at 65...If not happy with 391's you can go to a taller tire..had 410's with 29 inch tall tires and ran 65 at 3000.

HP on there ?? lower right sometimes ..

dats right...should be h440....if a 72 block

they show dimensions...check them out and compare

they have them..mine is a 3 row

I got mine from champion and it was direct fit...best warranty in the business.....

400 stroked to 451...friends 70 charger ran 12.40's in stock weight and suspension...1/4 mile time...not too shabby

I have run 20/50 in all my 440's....80 at start....65 to 70 when warm..old iron...likes heavy oil

4 hours out....3 to 3.5 in plus tuning ....

as long as there are no frame issues..I'd say a very good deal.... and good for you !!!

depends on wheel well and offset

if those are correct for the application then the spindles are somthing else...if they are for drums...get the correct ones for the application