Search results for query: *

Ok so last year I rebuilt my a833 with new bearings and seals from Brewers. My main bearings were pitted and did the typical noise 1-3 shifts but silent in 4th. We’ll every since I’ve rebuilt it I’ve been chasing a rattling sound that comes in at about 2700ish rpm and up. Doesn’t make the sound...

Hey guys, so Ive searched and if this is covered already I apologize I couldn't turn anything up. 68 Bee 4spd, about a year and a half ago I went through and inspected the trans during the restoration process. All synchros looked good as did everything else. put the cover back on and manually...

hey guys, so I’m rebuilding my hurst shifter mechanism. I was thinking of coating the plates with a dry lube. Any suggestion or other forms of lube you’d recommend?

68 a833 4spd: ok so I’m putting a new gasket between the case and the tail housing. I’ve followed Passons manual to a T and all keys and gears seem the be lining up good and seating till there’s about not quite 1/8” before the housings touch and it won’t go any more. I installed the main shaft...

Ok little advice needed here. I got new pressure plate bolts from ARP today. They didn't come with lock washers like the factory ones, only flat. Also they're torque spec is 45# were Mopars is 30#. I used the flat arp washers with red loctite and torqued to 30ft lbs. Now Im second guessing...

So I was cleaning my flywheel up today to get ready to install. It’s been off the car and in the shelf for about 5 years while doing the resto. While cleaning it I noticed small cracks. I know they’re from heat build up. I can’t feel any with my fingernail they’re just visible. It’s a stock...

Hey guys I’m installing my viton rear main seal from 440 source. Do I need to put a little oil or grease on the lip of the seal? I know rubber requires it but didn’t know about the viton. I’ve looked all over and can’t find it recommended. I’m installing following Hughes install instructions. Thanks