• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. machelis

    Measuring for new driveshaft

    Howdy, So I need a new driveshaft and I've read around about pushing the yoke in all the way and pulling out an inch. I can't bottom mine. I noticed some folks have a yoke seal that's about flush with the end of the tailshaft, but mine protrudes about an inch and starts to squish before I hit...
  2. machelis

    727 shift points

    Howdy, So i finally got my engine back in the car and put a few miles on her so far, but I've had to shift the car manually since on D it shifts waaay to quick. It's in 2nd by 8mph and 3rd between 12-14mph. I have a single rod kickdown that's been adjusted properly several times with the...
  3. machelis

    Neutral safety switch question

    Howdy, I have a 727 from a 72 newport in my 67 satellite with a very leaky 3 prong neutral safety switch. It's bypassed i also just discovered, so i was wondering if i should wire up a 3 prong connector and get the same switch, or if i should find a proper single prong and see if it would fit...
  4. machelis

    Valve spring advice

    Howdy, The 400 in my car has pitting in the cylinders, so I'm putting the top end together for my 383 magnum. I need new valve springs to go with what I'm told is an old crane 'cheater' cam. Something like .500 lift. It's going to be for street/strip use. There is such a wide variety of...
  5. machelis

    516 heads on a 400

    Howdy, I have a 1972 400 with 213 heads. I want the heads for another project, but I still want to drive my satellite with the 400 in it in the meantime. I have a set of 516 heads that need a rebuild. Will the 516 heads go on without any problems? It's going from open to closed chamber with...
Back
Top