Search results for query: *

I started this thread as a fellowship for engine builders past and present. I’m a rookie here and have my fingers crossed I’ll get my 318 build to fire up with no issues soon. So I probably wont get a lot of responses due to my experience level but for b bodies has yet to not provide me with...

Where does this tube end/terminate? Is it a dump tube?

I noticed my transmission oil pan has a little oil around the outer edge and a few of the bolds are shining with lite oil. The car does not run and there is little oil in the transmission as this is a project car and just installed the transmission and torqued the cover bolts. Slight gasket...

When installing a driveshaft in an automatic transmission do I need to lubricate either end. Into trany or rear diff?

I reassembling my 318 and am a bit concerned about the clearance from my crankshaft pulley and fan pulley. I purchased a w/ac water pump (didn’t realize it was w/ac when purchased)”the one that seems to be to close” no rubbing but less than 1/8”. I attached the old one (not reusable) and had...

What is this called and can’t recall how it was used/attached. The rod protruding. Thx

Anyone know the torque specs for these few bolts around the transmission?

I had a 318 short block built for me and I purchased a Melling M-72 oil pump separately. When going to install the mounting neck will not fit and I don’t want to force it. I check with my junker short block and it fit. The new rear cap is stamped 5-31 old (which fits) is stamped 1-31 can someone...

I cannot seem to locate a picture of the 100’s I took when dissembling my car of the engine and harmonic balancer order of assembly. There is a flat metal disc that I believe goes between the balancer and the block. Don’t know direction(side to face block) or if this is in the correct location...