Search results for query: *

Gentlemen, I am going to try to give you the readers digest version of my situation. I bought a 408 stroker short block that due to my own error I did not catch the fact that this short block must be used with open chamber heads. Shortly after taking delivery of the short block I have to...

Gentlemen, I am building a mild 360 4bbl in my 78 Magnum, The short block is the stock low compression 360 2bbl that Ma Mopar made millions of. Now I am in the process of installing a Comp Cams XE268H complete kit as well as an airgap intake and street demon 625 4bbl carb. The lean burn...

Gentlemen, In another post I showed the carnage from the broken crank on my 318 nested in between the fenders of my 67 coronet 440, I had always planned on running a stroker just had not planned on it being sooner then later. The 318 is setup now with a stock bottom end and stock bore...

So I find the time to fix the rear main seal leak and track down the on again off again rattle,knock that I could not tell if it was a crack flexplate or a bottom end issue. I get the transmission out and look what I found, I think the crank piece that broke off caused the torque convert...

Gentlemen, I will be installing steeper gears in my 67 Coronet soon, The car currently has an open diff 8 3/4 rear. I would like to change out to a limited slip style but there are allot of options out there. Sure grip cone or clutch style limited slip correct my if I am wrong this is your...

Gentlemen, So I have done a few upgrades to my 67 Coronet 440. Car was a 318 2bbl,auto,no power options, plain Jane go to church car. Just got done installing 2.25 dual exhaust, Edelbrock performer rpm air gap intake, Carter AFB 750cfm(Big I know but it was free), MP electronic ignition...

I picked up a Carter 9755s 750cfm carb for my small block stroker project and the part number comes back as GM universal linkage. This is my first mopar build is there anything with the tranny kickdown that I need to be worried about? Thanks in advance for any information I have learned allot...

Gentlemen, I have decided to warm over the 318 in my 67 Coronet just to make it more fun to cruise around in while I restomod the car and at later date swap in a bigblock. The engine is a bone stock 67 318 2bbl with 68,000 miles. The parts I gathered are as follows. 1.) Swapmeet Holley...

Hello, First I would like to thank you for taking the time to read this. Second I would like to apologize if this question has been beat to death in the past. My car is a 67 Coronet 440 with a 318 2bbl. I would like to ask opinions on the merits of a stroker small block such as the 318/390 or...