Search results for query: *

Looking for some advice here. I had my torsion bars out to do some front suspension work (new bushings, ball joints, tie rods, etc.). Ride height was good before I took them out. Now I re-installed everything and dropped the front end back down and its bottomed out. I've tried cranking in...

Hey guys, need some help. Which way does this seal go? Does the long rubber lip go in towards the bearing or out towards the spindle? This is the seal for my inner bearing on my front disc brake hub.

Working on rebuilding the front suspension on my 70 Charger with some components from PST. I noticed their LCA Bumpers are not the same as my originals. The PST bumpers are taller, narrower and not symmetrical. Since they are not symmetrical, I'm not sure if I should put the taller end more...

Working on rebuilding the front suspension on my 70 Charger with some components from PST. I noticed their LCA Bumpers are not the same as my originals. The PST bumpers are taller, narrower and not symmetrical. Since they are not symmetrical, I'm not sure if I should put the taller end more...

What started out as a brake caliper replacement has now turned into a full fledged front suspension rebuild...….you know how it goes, one problem leads to the next. Well, I pulled off my LCA and it appears that someone in the car's past history beat the hell out of the LCA shaft either to get...

So I decided to replace my front brake calipers because they were sticking (got some reman ones from Napa for $32 each). As long as I'm going to have to bleed my brakes, I got to thinking maybe I should also replace my rear drum cylinders. But then again, I looked at them and they don't appear...

Hi Guys, My 70 Charger has factory front disc brakes with 15 inch wheels. Planning to update to a newer drilled/slotted rotor and calipers. Any recommendations on which manufacturer to go with? Wilwood, SSBC, Baer, other? Both Wilwood and SSBC are about $880 and the Baer is expensive at...