Search results for query: *

So, I have an APSX Wideband O2 Air/Fuel gauge connected to my exhaust immediately aft of the header collector. Two bung's welded vertical and at a 45 degree. This is the fourth O2 sensor that has failed in as many months. Anybody using the APSX brand gauge? The first two that went bad- I...

Going through the many 'chapters' of new MSD ignition upgrade.. There is a reason MSD includes instructions on rotor phasing with their ignitions. I mistakenly thought since my engine ran fine and I wasn't going to alter distributor position, I should be fine- wrong. Only after the 6AL is...

68 RR with 383, electronic distributor, no AC. When installing an MSD 6AL-2, instructions say to 'bypass ballast resistor'. Regarding the ECU & BR harness: If I bypass the ECU, BR & remove them, don't they power or connect to anything needed? I have searched the forums and see different...

Anyone ever run into this? My harness pulled four pins out of my gauge cluster circuit board. Has anyone ever soldered these back on? Not sure where to source a replacement board? THANKS!!

So, in the constant search for the illusive 'spark chase' on my new-to me; RR. I have ran into a rather unique issue. With my front turn signal unplugged- Right; Front & Rear turn signals blink correctly. As well as Left Rear. However, when I plug in the drivers side front turn signal.. "they...

Just bought a 68 Belevedere and trying to fix the blinkers and tail lights. I have started to replace bulbs but I am thinking the PO installed the wrong bulbs. Where can I find the bulb chart for a 68? Thanks!!