Search results for query: *

Hey Guys. If any of you happen to be working on your '68-'69 and possibly '70 RR could and your rear bumper is fully mounted, could one of you kindly take a picture of the mounting brackets looking up from the undercarriage? Both sides? My bumper looks fine when looking at it but from the...

Hey Guys, Nothing big to report but I'm going to just rant for a bit. Admittedly I'm only doing it here as we are brothers in Mopar arms. Long story long, I purchased a '69 Road Runner back in 2012. Pretty much a plain jane job. Manual everything, nothing special. However it's my 1st B...

Howdy guys. I'm sure this is a well plied question but I thought I'd ask seeing as I can't find a definitive answer. Got a '69 money pi...er...Road Runner. Manual everything. Looking to do a front disc brake swap over the winter with an A-body brake setup I have. Obviously since I'm in...

Hey Guys, I know it has been a while since I posted but I thought I'd let those of you who care to know, know that I finished my little(?) project. I would have posted earlier but after finished up this floorboard and interior I then had to start on the clutch. As luck would have it the PO...

Hey All, just thought I'd catch some of you up to date on what has been going on with my flr board patch. So far...doing good. Got the panel in and welded up. Found some more rot in the rear corners of the passenger foot well where the rear and front floor pan meet so I had to spend...

Hi all! Hey...putting a new rug into my beeper and was wondering about the accel pedal gasket. Mine wasn't done right to begin with so I've nothing to go on. I understand that I have to cut a square into the rug and the jute that is about the size of the hump at the bottom of the pedal. If...

Okay B Body buds. Some of you were aware of my previous post about my floor board being rotted out under my go pedal. Thought I'd bring some of you up to speed as to where I'm at with my project since I've not posted a whole lot in the last two months. "Where have you been?" you ask...

Hello my fellow B Body members. Got a question I'm hoping one of you can help out with. I'm basically undoing a PO's half baked/half a$$ed work and I ran into something that just doesn't seem right with my 30+ years of Mope knowledge. Got a '69 bird with manual brakes. However the studs...

I'm sure some of you might have seen this before but this is a vintage video from Road Test. I find the narrarators comments about the driver 'feeling as though he is in control and not a computer" to be most amusing especially considering todays cars. https://www.youtube.com/watch?v=QMWikI9L7T0

Here is the story: Pulled the bench seat out of my '69 Beeper to have new springs put in it (they were too soft) and figured I'd pull the wiper pivots out to reseal them (they leaked) and would replace the rug since it was sun bleached. Once I got it all out, I found that the floor pan...

Hey guys, Gots a question and I'm hoping some of you can provide pixs to help me out. I'm wanting to run an aftermarket oil pressure gauge on my Beeper and for the life of me, I cannot find any holes in the firewall to route the oil line through OTHER than the hole that the accel cable runs...

Hi Gang, I have a cursory question for those of you who roam this site about the R/R and clutch replacement of a '69 RR. I know in princple the concept behind such: remove tranny, replace clutch, replace tranny, go, DUH! However I'm on the fence about taking it in and having it done or...

Hi all. Have a seemingly stupid question for you out there. Have a '69 RR which I took the side glass (driver side door) out of and had to remove the old rivet in the process. Not a problem since I purchased new glass rivets from Yearone. However I'm trying to figure out how to punch the...