Search results for query: *

Does anyone own a repop brewers 10.5" bell? It's got two fork pivot locations, which one is which? I called Dan, hes busy until 1. I'm trying to get this done while I have time this morning. I need the one for a 1969 b body. Any help would be appreciated

This may be a bit lengthy but I'll do my best to explain. I've got a road runner that is mostly done being restored. Sorting out all the issues now. I noticed it's got a fast shudder or vibration above 60 mph. It has a 3:91 suregrip out of my dart, had no issues in that car. So first thing I did...

I'm new to 4 speed cars. I just bought a 4 speed and the clutch is only a few inches from the floor and I feel like it's difficult to drive at times with small pedal travel. I pulled the trans and engine today to freshen things up and I found that it's a diaphram clutch. Based on what I've read...

So I have had two different transmissions leak from the front seal on the same 440. One transmission I pulled back out and replaced the seal and it still leaks. It leaks slow at first then gets worse over time. Near as I can tell from looking at the rubber on the seal, it looks like the seal is...

I recently rebuilt my 440, engine has stealth heads, comp lifters, comp cam, and stock stamped rockers. I did the cam break in without much trouble. Drove the car for about 10 min. Parked it and all of a sudden got a bunch of valve train noise. When I run the rpms up, it stops. I pulled the...

So i recently noticed some white vapor from my passenger side exhaust. The engine is a mild 440 with true duals. I pulled the plugs and saw water on the #4 cylinder. I did a leak down test, three cylinders came back 20%, #4 was 45%. I'm planning on pulling the head off. I'm thinking it could be...

So I'm kicking around the idea of buying a complete 4 speed conversion kit from brewers. I have a mild cast crank 440. I'm almost certain the crank has never been drilled for a 4 speed. From what I've read, I would have to use a Dakota bearing and cut the shaft. Brewers told me they would prefer...

Oi pressure question: I have a freshly built 440. After the engine is at operating temp, my oil pressure is around 19-21 psi in park idling at 1000 rpms. When in gear, foot on the brake it drops to around 13 psi, 600-650 rpm Is that too low? Temp question: Also, I have a 180 thermostat in the...

I have a Bouchillon kickdown cable on my 727/440 with holley avenger carb. I'm fairly certain I have everything installed correctly. The trans doesnt kick down unless I come to a complete stop. I currently have the valve lever completely open with full throttle on the carb. I tried it at eighth...

I'm a newb and building my 1969 coronet and have some questions. The engine is currently at the machine shop but will have the following: 74 smogger 440, cast crank, speed pro pistons at 9.4:1 cr, xe274 comp cam, stealth heads, performer rpm intake, msd, 1 3/4" headers, 6qt pan. 727 with 2400...