Wietse
Well-Known Member
Hey guys,
Today iv'e tested my 3 speed wiper motor which i want to install on my car.
As i have all the dashboard out i hooked it up to the dash switch for the wiper with some jumper wires.
I double checked the pins on the back and the wiring colours and hooked it up as per diagram.
All colours match anyway. (Green, Blue, Brown(tracer) and Red)
When testing it goes like this:
Position 1: Off/Return to park position
Position 2: Low speed
Position 3: High speed
Position 4: Medium speed
Thinking about it the switch cannot be wrong here, or is this a normal setup??
Could it be that during the refurbishment of the wiper motor 2 wires were installed incorrect/swapped around?
Anyone has any idea which wires should be swapped?
Today iv'e tested my 3 speed wiper motor which i want to install on my car.
As i have all the dashboard out i hooked it up to the dash switch for the wiper with some jumper wires.
I double checked the pins on the back and the wiring colours and hooked it up as per diagram.
All colours match anyway. (Green, Blue, Brown(tracer) and Red)
When testing it goes like this:
Position 1: Off/Return to park position
Position 2: Low speed
Position 3: High speed
Position 4: Medium speed
Thinking about it the switch cannot be wrong here, or is this a normal setup??
Could it be that during the refurbishment of the wiper motor 2 wires were installed incorrect/swapped around?
Anyone has any idea which wires should be swapped?
