john59oldcar
New Member
What radiator hoses to use? The water pump amd bottom tank are both on the drivers side. I have tried different hoses and no luck for either the top or bottom. Any help is appreciated.
440 Wedge Motor and 318 Poly re-cored (4) Radiator
- Thread starter john59oldcar
- Start date
Dodge 330
Well-Known Member
I did the same (radiator/440)
I bent up a piece of wire and went to the local O'reilly's for the upper hose and don't recall it's application.
AndyF on Moparts mentioned the one for the bottom. Let me see if I can find the number...
I bent up a piece of wire and went to the local O'reilly's for the upper hose and don't recall it's application.
AndyF on Moparts mentioned the one for the bottom. Let me see if I can find the number...
Dodge 330
Well-Known Member
Here, I finally tracked it down.
This is the one I used: Dayco 70678
I did have to shorten the bung on the bottom of the radiator as it interfered with the Baldwin full length oil filter.
So far so good!
This is the one I used: Dayco 70678
I did have to shorten the bung on the bottom of the radiator as it interfered with the Baldwin full length oil filter.
So far so good!
john59oldcar
New Member
Radiator Hose needs
Thank you for your help. I will use the wire for the top measurement. I just spent the money to re-do the 318 Poly radiator prior to restoring the car and it has the much wanted shroud too. I am relocating the oil filter on the inner fender and using a double filter, so I shouldn't have any space issues on the bottom.
Thanks
Again
Thank you for your help. I will use the wire for the top measurement. I just spent the money to re-do the 318 Poly radiator prior to restoring the car and it has the much wanted shroud too. I am relocating the oil filter on the inner fender and using a double filter, so I shouldn't have any space issues on the bottom.
Thanks
Again
Similar threads
- Locked
