64 Polara front sway bar

[moparmatt383]

Good morning everyone,

My Polara project is moving along. Front fenders are off and 318 engine is out so I figured this is a good time to replace some of the old front end bushings, etc…

I have a full sway bar set up out of my my 73 Cuda. Control arms, brackets, links, and bar. Will that stuff transfer over to the 64 Dodge. I believe the control arms are the same, but are the factory sway bar mounting tabs in the right location? I’ll do some test fitting, but figure I’d ask here first because I have to collect my parts from a few different locations.

Thank you!

Matt

 

[Dave6T4]

Not a direct bolt on, but can likely be adapted. Original style clamped to front strut rods, and was suspended from K- frame with links.

 

[lewtot184]

I bought a Firm Feel for my 65 coronet. Pretty straight forward install. Made a terrific improvement in the way the car handles.

 

[mobileparts]

—— 1973 —— Control Arms are very , very different from
1962 - 1972…..

 

[RemCharger]

62-66 1/2 66-69 70-72