• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

67 coronet 440 rr brake/turn

Davespa

Member
Local time
7:42 AM
Joined
Aug 29, 2014
Messages
12
Reaction score
0
Location
Orlando
hey all, I got a 67 coronet 440 383/727 that I cant seem to find why my right rear brake light an turn signal do not work? tail lights both work, left brake works, left turn works. I have continuity to the connector near the floor e brake from the bulb.. no power at that connector, from there? lost... THX! for any light shed on this deal!! p.s. I have a wiring book, cheap! cause it stops at THAT connector.
 
check for power/continuity behind the kick panel...or under the sill plate on that side...12v trouble light can penetrate the wire there...key on and see if it flashes with turn signal activated...then look at wire diagram to see,I believe, both go through turn signal switch
 
You can download a wiring diagram here http://www.mymopar.com/index.php?pid=27

Using a test light, check for voltage at the connector by the e brake for brake and turn?

Try checking for voltage at the turn signal connector near the base of the steering column also.

Not being a smart alec but you do have a good bulb and ground?
 
Thanks all, I got around to doing some checking, a lot! voltage, continuity, pulled steering column apart and come to find out for sure that my turn signal switch is wore out, if I play with the switch I can get lights to accually work! relief! pays to have a buddy watch tail lights while wiggleing switch lol, thx again!!! ps, anyone know where I can get a turn signal switch for under 300 bucks? lol
 
Auto Transport Service
Back
Top