Darius
Well-Known Member
Is there something better than the urethane bushings in my 4 link? They are trash after only 5800 miles!
Bushings
- Thread starter Darius
- Start date
mopar 3 B
Well-Known Member
You could try bearings. I have no idea as to where you would get them.
Not sure this will help but I'm finding there is a wide range of quality in poly-type bushings. You may just need to seek out a higher quality bushing. Probably easier said than done.
Darius
Well-Known Member
According to the folks at Ride Tech in the late 07-early08 time frame ( when I bought the 4 link from RMS) they had a bad supplier . This supplier used what THEY called "powder metal" for the sleeve. They resolved that issue and have not had a problem since. They are sending me FREE replacements!!
72Fourspeed
Well-Known Member
That is what was once called customer service. It is rare these days. Good on them.
Similar threads
