coronet 440 1966 2Dr HT

[Etan]

I everyone I'm new here and i have a problem with my wipers motor or linkage ?
Went i put the switch ON, the motor start but it can't move the linkage so i disconnect the linkage from the motor
and it run great and i try to stop it with my hand but i can't so i suppose this one is ok .After that i try to move the wipers from the linkage
it's work but it's seem to be stiff . the previous owner change the linkage himself i don't what to think!!!!
thank's

 

[toolmanmike]

Welcome to FBBO

 

[Etan]

thank's !

 

[Dave6T4]

Welcome to FBBO from Ontario. It sounds like one or both of your wiper pivots are trying to seize up. If you remove your wiper arms, these pivots can be unbolted from under the dash, and you can try to free them up. Before you reinstall them, purchase one of those pivot seal kits that many repro places sell. Not a fun job.

 

[Etan]

It's seem logic cause those wipers never been used in the last 40 years .
thank you !

 

[69Bee]

Welcome from AZ...

 

[Don Frelier]

Welcome from upstate NY conveniently located in the United States.

 

[PlymCrazy]

Greetings and welcome to FABO from NY!

 

[oldbee]

Welcome aboard from Ohio.

 

[polywideblock]

G, day from Australia

 

[KiwiKid72]

Welcome from New Zealand.

 

[Budnicks]

Welcome to FBBO

 

[YY1]

We're going to need to see that car.

 

[Jerry Hall]

Welcome from Alabama, wiper pivots are an easy fix with all the other stuff out of the way. Otherwise it's a PIA.

 

[Hey-O]

Welcome from Missouri!!