driveshaft length Hello from MN land of the frozen at the moment

[68coronet500]

I have a 68 coronet 500, 426 hemi, 833 4 speed, and a 9 3/4 dana . I am going to have a shaft made but require the center to center measurements. I have looked around and found several numbers that don't all match, the spec from a service manual would be good. So if anyone has a little time to check for me I would be very greatful. Thanks, Steve

 

[62MAX]

Check your PM's .

 

[Car Nut]

aboard Steve!

 

[super-bee_ski]

Welcome aboard Steve!
Brrrr...
You must have some Cold weather up there!
Anyway, thanks for joining the forum.
"super-bee_ski"

 

[mr. b]

welcome to FBBO from Pa

 

[aldal]

Welcome from another Minnesota Mopar fan. :hello2:

 

[Brandy]

Welcome from Vermont! Is it -75 with wind chill yet? Brrr...its 4 here and -10 with the wind.

 

[Budnicks]

welcome from warm & sunny {& draught ridden} NorCal

 

[Cranky]

Welcome to the site! You might post your question in the 66-70 Mopars forum. That should get more replies but I'm kinda surprised that the shop doesn't have a chart stating what you need. On the other hand, it's always good to measure the car it's going to be for...

 

[Gpuller]

Welcome from balmy southern MN!