- Local time
- 4:37 PM
- Joined
- Aug 5, 2011
- Messages
- 4,066
- Reaction score
- 6,294
- Location
- Lisle, HELLinois!
Hi Guys, I fabricated this Rotisserie to do my 68 GTX. Built strong enough to hold a complete car me thinks! The front & rear does not have to be tied together because I machined the
pins with a 3/8" section that is captured inside the barrel and installed a grease fitting. All
done with twirling it around, so this will go on to help someone else restore their project. I'm
asking $750.00 for it, and no way can this be shipped! Come & get it. Located in Lisle, Il.,
Comes with two long stroke hydraulic rams to lower/raise the car, and the balancers from Auto-Twirler to adjust the cars balance. I built it to use these because, hey, you can't make
everything! Thanks for looking!
Just west of Chicago.
pins with a 3/8" section that is captured inside the barrel and installed a grease fitting. All
done with twirling it around, so this will go on to help someone else restore their project. I'm
asking $750.00 for it, and no way can this be shipped! Come & get it. Located in Lisle, Il.,
Comes with two long stroke hydraulic rams to lower/raise the car, and the balancers from Auto-Twirler to adjust the cars balance. I built it to use these because, hey, you can't make
everything! Thanks for looking!
Just west of Chicago.
