Desert68Charger
Member
Hi folks,
I’m Brett, messaging from the UAE, I’m from the UK but been here for 8 years, I currently run a ‘65 Fastback Mustang and looking forward to getting into my new project, car is a non running ‘68 charger that will get a full bare metal rebuild.
Parts that I already have
Hellcat engine with loom and PCM
TR6060 gearbox
RMS front and rear suspension
New Ford 9” rear housing with 35 spline axels
Wilwood DP6 front brakes, 4 pot rears
Mcloud RST clutch (need new friction plates)
Parts I still need
Wheels - looking at the Aero 50, 15x10 rear and 15x8 front (need to ask the hive mind if these will fit over my DP6 calipers)
Oil and power steering coolers
Supercharger cooler
Wiring loom
Maybe a new Engine loom to replace the one on the donor engine from a Challenger
Need to flash the PCM to a crate engine setup
Fuel system
Brake and clutch masters
Probably a whole bunch of other stuff!!
Sure I will have 100 questions on the build, wish me luck!
I’m Brett, messaging from the UAE, I’m from the UK but been here for 8 years, I currently run a ‘65 Fastback Mustang and looking forward to getting into my new project, car is a non running ‘68 charger that will get a full bare metal rebuild.
Parts that I already have
Hellcat engine with loom and PCM
TR6060 gearbox
RMS front and rear suspension
New Ford 9” rear housing with 35 spline axels
Wilwood DP6 front brakes, 4 pot rears
Mcloud RST clutch (need new friction plates)
Parts I still need
Wheels - looking at the Aero 50, 15x10 rear and 15x8 front (need to ask the hive mind if these will fit over my DP6 calipers)
Oil and power steering coolers
Supercharger cooler
Wiring loom
Maybe a new Engine loom to replace the one on the donor engine from a Challenger
Need to flash the PCM to a crate engine setup
Fuel system
Brake and clutch masters
Probably a whole bunch of other stuff!!
Sure I will have 100 questions on the build, wish me luck!
