Help with 69 RR Convertible Rear interior Panel

[rhelwood]

Does anyone have a few good pictures of the interior rear panels installed? Being installed? Trying to look at how the interior panel lines up and how it secures. The top screw holes? Etc. I do not see anything in the parts or service manual. Wish I had a spare Conv to go by. Thanks for any help. Robert

 

[69B5]

Does anyone have a few good pictures of the interior rear panels installed? Being installed? Trying to look at how the interior panel lines up and how it secures. The top screw holes? Etc. I do not see anything in the parts or service manual. Wish I had a spare Conv to go by. Thanks for any help. Robert

Good evening, Robert
I don't have any pictures , I do have a 70 coronet vert. which should be the same.
I'm not exactly sure what you need to know.
The panel should fit in and line up once it's fit over the window crank stud
There should be recessed pockets that allow the panel to be screwed into place
I'm not sure if this helps.
But then I'm not sure of much. lol

69B5

 

[rhelwood]

Thank 69B5. I am looking to see how the interior panels connect to the body. I was missing the galvanized pieces that are used. Still would like to see the fasteners and how the fit is.

 

[resq302]

you might be able to get some good reference pics in my "Bringing it back to factory specs" thread. http://www.forbbodiesonly.com/moparforum/showthread.php?67715-Bringing-it-back-to-factory-specs

 

[rhelwood]

Thank You. One of the best sets of pics I have seen....

 

[resq302]

You are very welcome. I'm still no where close to being finished. Maybe half way there I'd say, so I'm sure there will be a lot more pics on there before I'm done! As for the interior.... that is finished though.