Anyone with a stock Hemi street intake ever measure their end wall gasket clearance when changing gaskets or cams? Sitting loose on .062” side gaskets, my front is measuring .130” to .0135” range. Hard to measure the back but seems pretty similar. From the positioning of the gaskets on the head with studs holding it and on the intake and with the intake on the engine, port and bolt alignment seem to be pretty good. Breakdown for any machine work is not in my immediate plans.
Trying to figure out my best bet for getting the 1/8”(+) end wall gaps to seal. Are the end wall gasket pieces with the Fel Pro 1234 gasket set that thick?
I’m thinking the problem I had sealing with RTV may be due to out of date stuff - but not sure.
Trying to figure out my best bet for getting the 1/8”(+) end wall gaps to seal. Are the end wall gasket pieces with the Fel Pro 1234 gasket set that thick?
I’m thinking the problem I had sealing with RTV may be due to out of date stuff - but not sure.