Hydraulic Roller Cam and Lifters-Hemi

[Hemirunner]

Comp CRH2513B/2516B HR12 Hydraulic roller cam new in box.
.609 lift intake, .589 lift exhaust
[email protected] int, [email protected] exhaust
112 LSA

This is a great hydraulic roller for a big crate hemi, never run the valves again:hello2:

Lifters are Comp 8921-16 hydraulic roller lifters. I stuck a rod through the side of my block before i was able to change over to this cam and lifters and new engine is going a different direction.

$650 for all plus the ride from Illernois....

 

[BCBOUND]

Hemi Roller

Could not find this cam in Comp Cams listing. Is it a custom grind? What is the application. Seems like it may be race and not streetable......

I may be needing something milder in the 500" Cross ram street motor Im building.

Are the lifters available separately??

 

[Hemirunner]

It's a custom hydraulic roller cam for a 500" or larger with good heads. I have another milder grind that's also NIB. It's a COMP 24-712-9 which is .574/.551 and 242/[email protected] on a 110. I'll make you the same deal on that as a package.

 

[Hemirunner]

I've also got a wedge hyd roller cam for a 500 stroker...

 

[BCBOUND]

PM Sent

 

[robinsonwr]

I've also got a wedge hyd roller cam for a 500 stroker...

What are the specs for the wedge camshaft? PM sent.

 

[Cranky]

Could not find this cam in Comp Cams listing. Is it a custom grind? What is the application. Seems like it may be race and not streetable......

I may be needing something milder in the 500" Cross ram street motor Im building.

Are the lifters available separately??

Are you building a cross ram Hemi?

 

[BCBOUND]

YES. I am building a 500" Cross Ram Hemi from a 440 + .030 and a pair of Stage V Hemi conversion heads for my 68 Barracuda.

I was going to go all out with 12 1/2's and a solid roller, but now Im thinking about loosing the hi domed pistons and going with pump gas and a hydraulic roller since it will see mostly cruise nites and few 1320 passes.

So Im in the market for pistons and cam/hyd rollers/push rods.

Any suggestions?