Is some type of reinforc. needed under bucket seats installed on a bench seat floor p

[LPalmer]

I am installing a bench seat floor pan out of a '69 Coronet donor car into my '69 Super Bee.
Is the floor pan strong enough to support bucket seats? Will I need extra reinforcement/support
under the floor pan for the Super Bee bucket seats? If so, who sells such supports?

 

[Hemi Rebel]

Bucket seat cars have an extra piece welded to the floor where the studs on the seat track go through.

 

[Redhorse719]

Yes you need 4 small pieces of metal, two on each inner side, to weld to the pan. They look like this: View attachment 205464www.ebay.com/itm/121106660463?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3A

 

[Hemi Rebel]

http://www.autometaldirect.com/body-components-floor-seat-brackets-c-23_135_272.html

 

[thomas patti]

bucket seats

yes,there are braces that are required for the inner two studs on the seat tracks. could be hard to find as I don`t think they re-pop. patti.look for bucket seat car if you can find one and cut or drill out the spot welds. thanks

 

[Hemi Rebel]

yes,there are braces that are required for the inner two studs on the seat tracks. could be hard to find as I don`t think they re-pop. patti.look for bucket seat car if you can find one and cut or drill out the spot welds. thanks

Click on link in post #4