More console questions....

[westie47]

What’s the beat way to fix these post backers on the console woodgrain panels? Can I solder them or do they need to be welded?

 

[Xp29h]

JB Weld maybe. I’d be careful with heat

 

[BeepBeepRR]

I think the material is die cast. Kind of like hotwheels. Id say soldier would work better I think welds would melt it.

 

[blue69runner]

Are you going to put new wood grain sticker on it. If so then would drill the plate and put new metal peg's on it. Then could use a tig welder.

 

[440 4 speed]

I think epoxy might work also. I am thinking of getting the absolutely flat headed bolts, extremely thin head. Then epoxy that to the top.

 

[westie47]

Are you going to put new wood grain sticker on it. If so then would drill the plate and put new metal peg's on it. Then could use a tig welder.

Yes I’m going to order the vinyl overlay. I don’t want to buy the whole panel.

 

[blue69runner]

Just to add Eazy weld sell some good rod's for cast and pop metal. Just used some on the bell housing. You might try them they have a rod for every thing.

 

[westie47]

I think epoxy might work also. I am thinking of getting the absolutely flat headed bolts, extremely thin head. Then epoxy that to the top.

Which bolts are those?

 

[westie47]

Just to add Eazy weld sell some good rod's for cast and pop metal. Just used some on the bell housing. You might try them they have a rod for every thing.

Is that for use with a MIG?

 

[440 4 speed]

Which bolts are those?

Hard to explain, but the head is no more than 1/8 of an inch thick, and quite large. Not sure, but might possibly be used in wood working. Maybe I can take a picture and post it, no guarantee.