R/T emblem location:1967 Coronet R/T quarter panel?

[Vincent Holt]

Looking for a diagram or measurements to install both R/T emblems back on my 67 coronet qrtr panels. Both qrtr panels were repaired. Need to put back the holes... Only want to drill once! Thanks.

 

[66ChargerHI-PO]

@Jerry Hall can probably help you out

 

[66ChargerHI-PO]

Here is an old picture I took a of 67 r/t at a show though, and to me here it looks like it goes on the front edge of the c-pillar almost in the middle of wheel well….

 

[66ChargerHI-PO]

Or in your case in your pictures, here where I circled and pointed. @Dave6T4 can likely help you out too….

 

[440 4 speed]

Try and look on the inner side of the fender and see if there’s body filler that came through the original holes. Unless you don’t have the original fender around.

 

[Jerry Hall]

I can't get any measurements today, maybe tomorrow.

 

[Jerry Hall]

I zoomed and cropped the previous picture.

 

[Sam69sat]

I can get you measurements for the holes in the next couple of days if no one else does. Looks like the most accurate would be from the edge of the coke bottle indents horizontally to the holes and from the body line that runs through the middle of the emblem vertically to the holes.

 

[Vincent Holt]

I can get you measurements for the holes in the next couple of days if no one else does. Looks like the most accurate would be from the edge of the coke bottle indents horizontally to the holes and from the body line that runs through the middle of the emblem vertically to the holes.

Ok great! I appreciate it!!