dodge68charger
Well-Known Member
Does anybody have pics and measurements of the rear bench seat belt retainers for a 68 charger. I need to give them to my interior guy so he can install them. Thank you
Seat belt retaining clip measurements
- Thread starter dodge68charger
- Start date
DP78
Well-Known Member
OK, so I did some quick measurements and took some pictures. This is in my 1970 super bee so hope it helps. Passenger side from edge of seat to leading edge of first screw is a hair longer than 17 1/4 inches. Outside screw to outside screw passenger side about 1 7/8 inches. This is the side where small clip goes. From bottom of seat to bottom of screws roughly 5/8 inch. Drivers side where the bigger clip goes, from outside of seat to leading 
edge of first screw 18 3/4 inches. From outside screw to outside screw 3 1/2 inches and again from bottom of seat to bottom of screws 5/8 inch. All measurements are basic and I have attached the following photos. I hope this helps out and thanks to all that have helped me out.
edge of first screw 18 3/4 inches. From outside screw to outside screw 3 1/2 inches and again from bottom of seat to bottom of screws 5/8 inch. All measurements are basic and I have attached the following photos. I hope this helps out and thanks to all that have helped me out.
dodge68charger
Well-Known Member
Thank you for the reply. Thats exactly what i was looking for. Gonna run these measurements out to my interior guy later this morning. Thank you sooo much for taking the time to send pics also. Much appreciated
- - - Updated - - -
Thank you for the reply. Thats exactly what i was looking for. Gonna run these measurements out to my interior guy later this morning. Thank you sooo much for taking the time to send pics also. Much appreciated
- - - Updated - - -
Thank you for the reply. Thats exactly what i was looking for. Gonna run these measurements out to my interior guy later this morning. Thank you sooo much for taking the time to send pics also. Much appreciated
Similar threads
